How It Works!

•  Step 1 - Apply a small amount (a dime sized dollop, as a little goes a LONG way) of StampBRITE! Cream Cleanser to dry stained stamp with a StampBRITE! Brush.  Make sure to work cream deep into stamp crevices.  Also, please be sure to avoid contact with the front of stamp as the cream can remove the stamp image. 
   

•   Step 2 - Once thoroughly applied to rubber, let StampBRITE! Cream Cleanser set on stamp undisturbed for ten minutes.
   

•  Step 3 - Squirt/Spray shallow layer of StampBRITE! Solution onto a plate appropriate to the size of your stamp.  For a small stamp, a teacup saucer works well.
   

• Step 4 - Place rubber stamp rubber side down into layer of StampBRITE! Solution and let sit for 1 minute.
   

• Step 5 - Lift stamp from StampBRITE! Solution and start to gently brush stamp surface with a StampBrite! Brush, being careful not to allow fluid to seep over sides to the front of the stamp.  You should see a considerable amount of ink lifting from the rubber during this step. 
   

• Step 6 - Once you have thoroughly brushed the rubber, rinse your plate leaving a shallow layer of tap water.  Place your stamp in the water to allow StampBRITE! Cream Cleanser and StampBrite! Solution to soak off.
   

• Step 7 - Scrub and dry stamp with StampBRITE! Towelette.

Note: If any StampBRITE! Cream Cleanser remains on stamp, repeat steps 6 and 7, using clean StampBRITE! Brush to get into deep crevices.

For deeply stained stamps entire process may need to be repeated. 

BEFORE

AFTER

A clean stamp is a happy stamp!